Drum pump – Explosive media

for highly flammable hydrocarbons

SKU: Drum pump - Explosive media Categories: , ,


Product information “Drum pump – Explosive media”

Motor: MD2xL – 1000W, 6 bar, comfort handle (for higher delivery head, viscosity and density)
Immersion depth: 1200 mm (sealless)


The Drum pump is suitable for low viscosity, flammable and combustible hydrocarbons. Perfectly suited for the removal or decanting of solvents.

  • Optionally available with Ex – plug
  • Pump tube equipped with Lutz original hand wheel
  • Suitable for filling or transferring alternative fuels, oils, flammable liquids

Features & Advantages

  • Optionally with electric or compressed air drive
  • No lubricants and therefore no contamination of the pumped medium by lubricants
  • Highly resistant noble carbon shaft bearings
  • Maintenance without special tools
  • Seal modules of the seal-less (SL) pump can be replaced
  • Approved according to ATEX directive 2014/34/EU, category 1/2
Technical data
Suitable media: Essigsäure, Butanol, Styrol, Toluol, Nikotin, Butylacetat, Äththylacetat, Aceton, Ameisensäure, Ethanol, Benzin, Petroleum, Methanol, Kerosin, Isopropanol
Pump tube (material): Niro (Edelstahl)
Impeller (material): ETFE (ethylene-tetrafluorethylene copolymer)
Static seal (material): no seals in contact with the medium
Mechanical seal (material): no seals in contact with the medium
Bearing (material): Edelkohle
Drive shaft (material): Edelstahl (1.4571)
Flow rate (up to max. GPM)*: 27
delivery head (up to max. ft)*: 56, 66
Temperature of medium (max °F): 212
density (up to kg/dm³): 1,7, 2.8
Operating pressure (max. psi): 87
Viscosity (up to max. cps)*: 750, 1000
Type of impeller: Radial-flow impeller
Seal type: Sealless (SL)
Immersion length: from 39″ (1000 mm), from 47″ (1200 mm)
Immersion tube diameter (up to mm): 1.6
Thread (inch) outside: 1 1/4″
Type of drive: Electric, Compressed air
Output (W): 640, 1000
Voltage: 120
Frequency (Hz): 60
Version: mit Unterspannungsauslöser, Komfortgriff

* The maximum flow rate is a value determined by means of a test bench and measured with water at a medium temperature of approx. 20 °C. The measurement is carried out at the pressure joint of the pump, without hose, nozzle or flow meter. The achievable flow rate in use is lower and depends on the individual application, the liquid properties and the configuration of the pump. The max. delivery head also depends on the pump design, motor and fluid. The viscosity values are determined with oil.

** Test assembly: Medium water / diesel, flow in preferred direction, settling section 0.2 m upstream and downstream of flow meter

Additional information

Immersion depth:

"39' / 1000 mm (for emptying drums)", "47' / 1200 mm (for container emptying)"


"ME I 6 – 640W, 120V", "MD2xL – 1000W, 6 bar, convenient grip"