Pump tube PP

suitable for B2 Vario and B2 Battery

SKU: Pump tube PP-1 Categories: ,


Product information “Pump tube PP”

Diving depth 700 mm
Seal type: Sealless (DL)


The Lutz Pump tube (PP) is suitable for corrosive, aqueous to slightly viscous media. Depending on the application, various Motors are available which you can combine with the Pump tube at any time. This means you are flexible at all times and thus save important resources.

  • also available in special immersion depths from 200 – 2500 mm
  • Pump tube equipped with Lutz original hand wheel
  • Suitable for decanting or transferring oils such as rapeseed oil and vegetable oil

Features & Advantages

  • Optionally with electric or compressed air drive
  • No lubricants and therefore no contamination of the pumped medium by lubricants
  • Optimized Drum emptying
  • Universally resistant PTFE shaft bearings
  • Maintenance without special tools
  • Seal modules of the mechanical seal (MS) or seal-less (SL) pump can be replaced
Technical data
Pump tube (material): PP (polypropylene)
Impeller (material): PP (polypropylene)
Static seal (material): no seals in contact with the medium
Mechanical seal (material): no seals in contact with the medium
Bearing (material): ETFE / PTFE
Drive shaft (material): Edelstahl (1.4571)
Flow rate (up to max. GPM)*: 24
delivery head (up to max. ft)*: 69
Temperature of medium (max °F): 122
density (up to kg/dm³): 1.9
Viscosity (up to max. cps)*: 800
Type of impeller: Radial-flow impeller
Seal type: Sealless (SL)
Immersion length: from 19″ (500 mm)
Immersion tube diameter (up to mm): 1.6
Thread (inch) outside: 1 1/4″
Type: PP 41-L-DL SS

* The maximum flow rate is a value determined by means of a test bench and measured with water at a medium temperature of approx. 20 °C. The measurement is carried out at the pressure joint of the pump, without hose, nozzle or flow meter. The achievable flow rate in use is lower and depends on the individual application, the liquid properties and the configuration of the pump. The max. delivery head also depends on the pump design, motor and fluid. The viscosity values are determined with oil.

** Test assembly: Medium water / diesel, flow in preferred direction, settling section 0.2 m upstream and downstream of flow meter

Additional information

Immersion depth:

"19' / 500 mm (small vessels)", "27' / 700 mm (for emptying canisters)", "39' / 1000 mm (for emptying drums)"